MATSONIC MS9007C, Руководство пользователя

Страница: 50 / 78

44
IDE Primary/Secondary Master/Slave (Auto)
Leave this item at Auto to enable the system to automatically
detect and configure IDE devices on the channel. If it fails to find
a device, change the value to Manual and then manually config-
ure the drive by entering the characteristics of the drive in the
items described below.
Refer to your drive's documentation or look on the drive casing if
you need to obtain this information. If no device is installed,
change the value to None.
Note: Before attempting to configure a hard disk drive,
ensure that you have the configuration information
supplied by the manufacturer of your hard drive. In-
correct settings can result in your system not
recognizing the installed hard disk.
Access Mode (Auto)
This item defines ways that can be used to access IDE hard
disks such as LBA (Large Block Addressing). Leave this value
at Auto and the system will automatically decide the fastest
way to access the hard disk drive.
Press <Esc> to return to the Standard CMOS Features page.
Drive A/Drive B (1.44M, 3.5 in./None)
These items define the characteristics of any diskette drive
attached to the system. You can connect one or two diskette
drives.
Floppy 3 Mode Support (Disabled)
Floppy 3 mode refers to a 3.5-inch diskette with a capacity of
1.2 MB. Floppy 3 mode is sometimes used in Japan.