MATSONIC MS9007C, Руководство пользователя

Страница: 34 / 78

28
Note: The ribbon cable connectors are keyed so that they
can only be installed correctly on the device con-
nector. If the connector is not keyed, make sure that
you match the pin-1 side of the cable connector with
the pin-1 side of the device connector. Each con-
nector has the pin-1 side clearly marked. The pin-1
side of each ribbon cable is always marked with a
colored stripe on the cable.
3. Plug the correct connector on the FDD cable for the
5.25-inch or 3.5-inch drive into the FDD connector (B).
4. Plug a power cable from the case power supply into
the power connector on the FDD (C).
When you first start up your system, go immediately to the
Setup Utility to configure the floppy diskette drives that you
have installed. See Standard CMOS Features on page 42 for
more information.
Installing Add-on Cards
This mainboard has six 32-bit PCI (Peripheral Components
Interconnect) expansion slots, one 4xAGP slot, and one
Communications and Networking Riser (CNR) slot.
4xAGP Slot The 4xAGP slot is used to install a graph-
ics adapter that supports the 4xAGP
specification and has a 4xAGP edge con-
nector. The 4xAGP slot only supports 1.5V
4xAGP and 2xAGP cards.
PCI Slots PCI slots are used to install expansion
cards that have the 32-bit PCI interface.
CNR Slot This slot is used to insert CNR cards in-
cluding LAN, Modem, and Audio functions.