49
Swap Floppy Drive
Default: Disabled
If you have two floppy diskette drives in your system, this item allows
you to swap the assigned drive letters so that drive A becomes drive B,
and drive B becomes drive A.
Boot Up Floppy Seek
Default: Enabled
If this item is enabled, it checks the geometry of the floppy disk drives at
start-up time. You don’t need to enable this item unless you have a
legacy diskette drive with 360K capacity.
Boot Up NumLock Status
Default: On
This item defines if the keyboard Num Lock key is active when your
system is started.
Gate A20 Option
Default: Normal
This item defines how the system handles legacy software that was
written for an earlier generation of processors. Leave this item at the
default value.
Typematic Rate Setting
Default: Disabled
If this item is enabled, you can use the following two items to set the ty-
pematic rate and the typematic delay settings for your keyboard.
Typematic Rate (Chars/Sec)
Default: 6
If Typematic Rate Setting is enabled, you can use this item to define
how many characters per second are generated by a held-down key.
Typematic Delay (Msec)
Default: 250
If Typematic Rate Setting is enabled, you can use this item to define
how many milliseconds must elapse before a held-down key begins
generating repeat characters.
Security Option
Default: Setup
If you have installed password protection, this item defines if the pass-
word is required at system start up, or if it is only required when a user
tries to enter the Setup Utility.
