Matrox Monarch LCS, Руководство пользователя, Страница: 25 / 106

13
Matrox Monarch LCS hardware
During a standard boot up sequence, various LEDs will flash on and off. The
Warning (
) LED will begin to flash early during the boot up sequence, and
once it stops flashing, the Monarch LCS is ready for use.
Switch to Static IP mode
You can switch your Monarch LCS device to Static IP mode by pressing the
ENCD button while the Encoder LED flashes during the power-up sequence.
1
Press the Reset button on the device to initiate a device reboot. During the
power-up sequence (see
“Powering Monarch LCS” on page 11 ), the Encoder
LED flashes for three seconds.
2 Press the ENCD button on the device while the Encoder LED is flashing.
This sets the device to Static IP mode and the Static IP address to its default
address (169.254.1.11).
The device is ready when the Warning ( ) LED stops flashing; however, the
Warning LED ( ) may remain on if there is an error condition (see “Status
page” on page 26 for more information).
Reset to factory defaults
When resetting Monarch LCS using this method, all Monarch LCS settings reset
to factory defaults, the device password resets to
admin , and the device powers
up in DHCP IP mode for connecting to a network with a DHCP server, such as a
router. To switch the device to Static IP mode after performing a factory reset, see
“Switch to Static IP mode” on page 13 .
You can also use a factory reset to load pre-configured Monarch LCS settings
from a configuration file. For more information, see
“Automatic Configuration”
on page 48 ).
To reset Monarch LCS to factory defaults, press and hold the Reset button on the
device for at least five seconds. The device begins a power-up sequence during
which various LEDs will flash on and off. The Warning (
) LED will begin to
flash early during the boot up sequence, and once it stops flashing, the Monarch
LCS is ready for use.
The Warning LED ( ) may remain on if there is an error condition (see “Status
page” on page 26 for more information.