Matrox Convert DVI, Инструкция по установке и эксплуатации

Страница: 52 / 70

44
Chapter 4, Configuring Matrox Convert DVI
$
Best fit Outputs the content as either letterbox or pillarbox video,
depending on the input and output resolutions, while maintaining the
content’s aspect ratio.
This feature is especially useful when you want to connect different
resolutions to Convert DVI’s input when in stand-alone mode. When input
detection is selected, the programmed region of interest settings, and the
programmed Convert DVI desktop resolution, are ignored.
7
Under Stand-Alone Mode , click Program Current Settings to copy the
current settings to your Convert DVI’s internal memory. When programming
is complete,
Programmed will appear in the status window.
²Caution
Do not disconnect Convert DVI’s USB cable or power cord until
the programming process is complete. Doing so may damage your Convert
DVI hardware.
Using Convert DVI in stand-alone mode
After programming your Convert DVI for stand-alone mode (see “Programming
Convert DVI for stand-alone mode” on page 43 ), perform the following steps to
use your Convert DVI in stand-alone mode.
1 Connect Convert DVI as shown in “Connections for using Convert DVI in
stand-alone mode” on page 17 .
¦ Note Ensure that the Convert DVI USB cable is disconnected from the
Convert DVI.
2 Disconnect and then reconnect the power cord from Convert DVI. Your
Convert DVI will boot in stand-alone mode.
¦ Note
You cannot make any changes to the Convert DVI settings when
connected in stand-alone mode. To change the Convert DVI settings, Convert
DVI must be connected using the USB cable to a computer that has the Convert
DVI software installed. See
“Programming Convert DVI for stand-alone mode”
on page 43 for instructions on changing the Convert DVI stand-alone settings.