Matrox Convert DVI, Инструкция по установке и эксплуатации

Страница: 51 / 70

43
Specifying your administrator settings
Programming Convert DVI for stand-alone mode
To use Convert DVI in stand-alone mode, you must first program your desired
stand-alone settings in Convert DVI's internal memory as described in this
section.
¦ Note If you install a new version of the Convert DVI software that initiates a
firmware update on your Convert DVI, the programmed stand-alone settings will
be erased from Convert DVI’s internal memory.
1
Make sure that Convert DVI is connected to your computer via the Convert
DVI USB cable (see
“Connecting Convert DVI for programming stand-alone
mode” on page 12 ), and that the computer has the Convert DVI software
installed.
¦ Note
The Convert DVI USB cable must be connected in order to make
changes to the Convert DVI settings and to program your Convert DVI for
stand-alone mode. The USB cable is not required to use Convert DVI in
stand-alone mode. When connecting the USB cable, it may take up to a minute
for the Convert DVI video output to resume. If the Matrox Convert DVI
Control Panel does not respond after you have connected the USB cable, close
and then re-open the control panel.
2
Set the Convert DVI desktop resolution to match the output resolution of the
DVI device that you want to use with Convert DVI in stand-alone mode.
However, if Convert DVI’s input detection feature is enabled (see step
6 ), the
Convert DVI desktop resolution will be ignored and Convert DVI will detect
the output resolution of your DVI device. For information on setting your
Convert DVI desktop resolution, see
“Configuring your display settings for
use with Convert DVI” on page 20 .
3 Open the Matrox Convert DVI Control Panel.
4
Specify your Convert DVI settings. These settings will be used by your
Convert DVI when in stand-alone mode.
¦ Note
Only the settings that have been applied to your video output will be
copied to your Convert DVI’s internal memory. If you make changes to the
Output or Genlock settings, make sure to click Apply on those pages before
programming for stand-alone mode.
5
Click Output .
6 Under Stand-Alone Mode , select Input detection if you want Convert
DVI to automatically detect the output resolution of the DVI device
connected to Convert DVI’s input, and output the entire Convert DVI
desktop (DVI input) according to the selected
Output scaling mode :
$
Anamorphic Outputs the content as full-screen anamorphic video.