Matrix A3x-01 Ascent Trainer, Руководство по обслуживанию

Страница: 38 / 69

34
cHAPter 8: PArt rePlAceMent gUide
8.6 belts reMoVAl And instAllAtion
1) Turn off the power and disconnect the cord from the machine.
2) Remove the front disks from the machine as outlined in Section 8.1.
3) To remove the drive belt, loosen the belt tension bolt on the left side of the tension pulley and rotate the pulley counter-clockwise until there is
enough slack in the belt to remove it (Figures B &C).
4) To remove the ECB belt, loosen the 6 bolts holding the ECB to the frame (Figure D).
5) Loosen the 11 mm nut on the tension loop bolt until there is enough slack in the belt to remove it (Figure E).
6) Install the replacement belt(s) and reverse necessary steps to secure the assembly until the belt is tight. Tighten the 6 ECB bolts to 12 N-m
torque. Tighten the drive belt to 180 lbs. for a new belt, 150 lbs. for a used belt. Tighten the ECB belt to 120 lbs.
7) Test the Ascent Trainer for function as outlined in Section 8.20.
figUre A figUre b
figUre c figUre d
figUre e