Matrix Vision mvBlueLYNX-X, Техническое руководство, Страница: 92 / 236

Open a terminal window. 1.
setxkbmap -model pc105 -layout de
2.
You could put the above line in a file in the directory
/etc/profile.d
in order to set the keyboard after
rebooting.
(You might need to install
setxkbmap
from the stable feed like this:
opkg install setxkbmap
)
11.4 VGA resolution
By default , the mvBlueLYNX-X has been pre-configured at a resolution of 1024 x 768 pixels, 24 bit @ 60
Hz . DDC - I²C lines are available, however, they are not used for the automatic resolution detection.
If you want to change the resolution permanently, you have to edit the
/media/mmcblk0p1/uEnv.txt
.
By default , the following line can be found there:
dvimode=1024x768-24@60
The maximum possible resolution depends on the pixel clock not exceeding 75MHz i.e. a resolution of
WXGA 1280 x 800 @ 60Hz (=71MHz) is possible.
11.5 Network configuration
By default
, the mvBlueLYNX-X gets its IP address via DHCP automatically.
Depending on the configuration of the network or the mvBlueLYNX-X (more precisely: if DHCP is used or
not), the following IP addresses are assigned:
If the mvBlueLYNX-X is configured to use a static IP address, the mvBlueLYNX-X will use this one.
In this case, the mvBlueLYNX-X will only be accessible if the IP address is valid for the current
network. 1.
With DHCP, the mvBlueLYNX-X will get an IP address from the DHCP server (default). 2.
Without DHCP, the mvBlueLYNX-X will start with a logical link address (LLA) / zero configuration
class B IP address ("169.254.X.X", netmask 255.255.0.0). 3.
mvBlueLYNX-X Technical Manual
82 22 April 2016 Version - 1.49 MATRIX VISION GmbH