MSC-HD42L Product Manual
is usually only used with SDI video, but is not limited to that video type.
3D support options
1. Paired I/O using a single router device. Resulting 3D matrix size is half of the devices original size, for
example an 8x8 router would yield a 4x4 3D router. Not available with devices with less than 2
destinations or sources. I/O pairs are consecutive, for example output 1 and 2 would be for the first 3D
channel, 3 and 4 would be for the 2nd, etc.
2. Dual linked router devices. Uses 2 devices connected via TCP/IP over their Ethernet ports, one acting as
a master, to provide 3D support. Devices must have the same matrix size. Resulting 3D matrix is equal
to the matrix size of a single device, for example two 8x8 routers would result in one 8x8 3D router. One
router controls one half of the 3D channels (right eye) and the other controls the other half (left eye).
Option 1 is enabled through the
3D I/O Pairing
setting and Option 2 is enabled by setting the
Control Mode
to
Remote Sync (3D)
and assigning the secondary router's IP address to the
Remote Router IP
setting. All of
these settings can be found on the
of the Web Page Interface. Refer to the
Config Tab - Button Panel Settings
sections for additional details.
Page 12 of 55
Copyright © 2013-2015 Matrix Switch Corporation
