1.1 Attaching the probe clip
A template is supplied to permit accurate positioning of the clip. Note that the adhesive
on the clip is permanent, and once fitted, the clip is not easily removed.
1. Clean the rear of the box using the wipe supplied. Allow the surface to dry.
2. Position the template onto the rear of the instrument as shown in Figure 1.
3. Peel off the paper that protects the adhesive on the back of the clip.
Assembly
aid
Probe
clip
Rear of
case
Figure 2 Probe clip template
4. Carefully position the clip in the position defined by the template and press it firmly in
position.
5. Remove the template.
6. The probe can now be clipped to the instrument for one-handed operation. Pass the
cable through the slot in the clip, then push the probe into the clip until it clicks into
place.
7. To remove the probe, simply pull it forward out of the clip
.
INT-0124-XX 5
