Installation
Page 10
3.4
Adjust the pendulum compensation.
To ensure the horizontal position of the blade in lifted position, the pendulum compensa-
tion springs are attached. The springs are preset in the factory and should only be read-
justed as required, i.e. if the blade does not hang horizontally in lifted position.
1.
Lift out the snow blade.
2.
Tension the springs by turning the laterally attached screws. Only tension the
springs that are opposite of the side on which the blade hangs down.
Fig. 9: Adjusting the pendulum compensation
Note!
The pendulum compensation element must be easy to move. Ensure that
the stop nuts on the pendulum compensation allow slight play of approx. 0.5
mm between pendulum plate and pivot bracket.
Pendulum compensation
springs
Inner - pressure piece
Screw
