Attaching and detaching the CLS 650/850
Page 33
17. Connect the hydraulic connections of the CS to the connections on the tractor.
18. Connect the plug-type connector to the tractor's 12 V power connection.
6.7
Detaching the CLS from the basic hitch
Proceed as follows to detach the CLS-G/H 650/850 from a basic hitch:
1.
Turn the threaded sleeve of the upper link to adjust it to a minimum length.
2.
Insert the support wheels and arrest the support wheels with the tube linch pins.
Fig. 55: Support wheel
3.
Disconnect the hydraulic hose connections.
4.
Unplug the plug-type connector from the power connection.
5.
Disconnect the suction hose from the connector on the CLS by loosening the appro-
priate hose clamp.
Fig. 56: Suction hose on the turbine cover
6.
Unlock the lock bolts on the lower link of the hitch, see Fig. 50.
7.
Turn the upper link to tilt the CLS to the rear.
8.
When the upper link is offloaded remove the upper link bolt on the tractor to discon-
nect the upper link connection.
9.
Loosen the clamp lock of the front support wheel on the CLS, lower the support
wheel, then arrest the clamp lock (see Fig. 53)
10. Crank the front support wheel until the connecting tube is lifted out of the hooks on
the basic hitch.
11. Push the CLS back a short distance.
12. Uncouple the PTO shaft on the tractor.
To do this proceed as described in section 5.2.3.
13. Drive the tractor forward, away from the CLS.
Hose clamp
Tube linch pin