Attaching and detaching the CLS 650/850
Page 31
1.
The CLS-G/H 650/850 rests on the support wheels.
Fig. 49: Moveable support wheels
2.
With the tractor in reverse, approach the CLS.
In this process align the lower link of the hitch so that the linch pins are in front of the
cross strut of the CLS.
3.
Push the CLS as close as possible to the tractor.
4.
Unlock the locking pins on the lower links of the hitch.
5.
Couple the PTO shaft to the tractor and to the CLS. To do this proceed as described
in section 5.2.2.
6.
Crank the front support wheel of the CLS and push the implement toward the tractor
until the cross strut is positioned above the catch hooks of the basic hitch (see Fig.
50).
Fig. 50: Locking pin (unlocked) on the lower link
7.
Crank the front support wheel of the CLS until the connecting tube rests in the notch
of the basic hitch.
8.
Lock the locking pins (see Fig. 51).
Fig. 51: Locking pin (locked)
9.
Adjust the length of the upper link to match the distance between the upper link lugs
on the CS and the lugs on the tractor.
Locking pin
Tube linch pin
Locking pin