First installation
Page 17
5.2.2
Mounting the PTO shaft
1.
Press the locking pin on the outer fork and keep it depressed.
2.
Slide the outer fork onto the profile stub of the rear universal joint shaft on the trac-
tor.
3.
Release the locking pin.
4.
Slightly move the PTO shaft back and forth until the locking pin audibly locks in
place.
5.
Repeat steps 1 to 4 to attach the PTO shaft to the CLS.
6.
Hook the PTO shaft safety chains to a stationary part on the tractor and on the CLS
(see Fig. 22).
Fig. 22: Safety chain on the PTO shaft
5.2.3
Dismounting the PTO shaft
1.
Detach the safety chain on both sides.
2.
Press the locking pin on the outer fork and keep it depressed.
3.
Pull the outer fork down from the profile stub of the PTO shaft on the tractor.
4.
Release the locking pin.
5.
Repeat steps 2 to 4 to dismount the PTO shaft on the CLS.
5.3
Mounting the suction connector and the suction hose on the tractor
Danger!
The operator or persons near the tractor/implement can be severely injured.
Switch off the tractor engine and remove the ignition key before mounting
the basic hitch.
Attention!
If you dismount the suction connector, mount the original discharge guard.
Never operate the mower without either the discharge guard or the suction
connector installed.
Note!
In addition to this manual also read the safety and operating instructions
specified in the associated mower manual.
