Matermacc Irrigamatic P350, Руководство по эксплуатации и техническому обслуживанию

Страница: 7 / 28

REV 0/00
5. CARRYING OUT THE IRRIGATION CYCLE
For a correct irrigation procedure, we reccomend executing the various phases in the right order as
described below.
PHASE DESCRIPTION
Switch console on.
Unwind the tube. The console will measure and display
the meters of tube being unwound.
Programming the working cycle.
Start the working cycle by pressing START.
End of working cycle
1 (see par. 6 - page 04)
2
(see par. 7 - page 05)
3 (see par. 8 - page 06)
4 (see par.9 - page 11)
5 (see par. 10 - page13)
Pag.04
6. STARTING-UP
6.1 SWITCHING THE CONSOLE ON
6.2 INITIALIZATION
Press key .
1
3
4
The IRRIGAMATIC model and the version of the installed program is displayed
(for ex. v1:45)
The console carries out a series of tests and preliminary operations automatically.
Then some info is displayed such as:
Present time (for ex. 10:34)
End-of-work motor is set in closed valve conditions.
Speed adjustment motor is set in conditions of zero speed.
2
"Batt OK" or "Batt err"
Voltage and charge of the
supply battery
ON
OFF
6.3 END OF START-UP PHASE
When this is displayed, the console is ready to be programmed (PGM) and awaits
hose unwinding.
If the message is displayed, however, the console does not wait for hose
unwinding, but continues its working cycle from the point where it had been
interrupted.
Not End
See par. 13 page 17 message
Not End