Matermacc Irrigamatic P350, Руководство по эксплуатации и техническому обслуживанию

Страница: 15 / 28

REV 0/00
Pag.12
9.4.1 VISUALISATIONS WITH END-OF-IRRIGATION LIMIT TIME
1 Clock.
2 Speed.
(Vi).
3 Pause.
Initial pause
9.4 SPECIAL VISUALISATIONS
If during the execution of the working cycle the end-of-irrigation limit time function
is active (see paragraph 11.3 page 15), the console signals
A small "o" blinks between the hours and the minutes
The speed displayed (Vo) is calculated by the console to finish the
irrigation at the established time, instead of the programmed speed
(only if programmed)
To finish the irrigation within the set limit time, the console can reduce the time
programmed for pauses. In particular:
Both the initial pause minutes that had been programmed,
displayed by
(for ex. 5 min) and the minutes calculated by the console,
(displayed with a little "0") are displayed at the same time.
(For ex. 1 min).
rI
this condition as follows:
end-of-irrigation based on the programmed meters of hose to be rewound
And not on the total meters of hose that have been unwound. This is
the reason why the time calculated is displayed with a small "z" blinking
between the hours and the minutes.
Final pause
9.4.2 VISUALISATIONS WITH END-OF-IRRIGATION PROGRAMMED AFTER
A CERTAIN NUMBER OF REWOUND METERS
Both the final pause minutes that had been programmed,
displayed by
(for ex. 5 min) and the minutes calculated by the console,
(displayed with a little "0"), are displayed at the same time. (For ex. 1 min).
If the function has been enabled (see par. 11.2 page 14), by pressing
key (see par. 8.3 page 10) the console will display the time expected for
It is possible to use this function also in combination with the end-of-irrigation limit
time function.
rF
h