Matermacc Irrigamatic P350, Руководство по эксплуатации и техническому обслуживанию

Страница: 20 / 28

REV 0/00
Pag.17
13. DISPLAY MESSAGES
13.1 OPERATING MESSAGES
Stop Press0
Reg?
m/h^^^
Not End
This message can only be displayed if the pressure switch is connected to the
console. It shows the pressure in the hose has fallen below the pressure switch
calibration value. The pressure switch is only checked during the working cycle.
When there is not enough pressure in the hose, the cycle is interrupted.
The end-of-work valve is set on closed valve condition.
The speed adjustment motor is set on zero speed.
The console remains in stand-by until the pressure returns above the pressure
switch calibration value. While the inactivity the following message is displayed.
When the pressure returs, the console will automatically continues the irrigation
cycle from where it has previously been interrupted.
the speed adjustment motor is controlled by the
console in order to maintain the programmed speed.
When the motor reaches end of stroke, the console will display this condition as
follows:
If this message is displayed and the measured speed is lower than the
programmed speed, it would mean that the highest possible speed of the irrigator
has been reached.
Therefore the programmed speed value or the machine adjustments should be
modified.
if the rewinding speed exceed
250 m/h, the console would display the following message:
The message might appear at the end of the starting phase.
This message means that the console has been switched off when the irrigation
cycle was not over yet. Consequently the end-of-rewinding sensor was not
activated.This is the reason why this message is displayed when switching on the
console and the cycle starts again automatically from the point where it had been
interrupted.Should you wish to restart a new cycle deleting the programmed
values, a RESET operation should be carried out. (See par. 14 page 22)
Should you wish to restart a new cycle deleting the programmed values, a
CLEAR operation should be carried out. (See par. 14 page 22)
During the working cycle,
During the working cycle,