4. Prepare base for vise installation
• The base should always be in the fully open position when a vise is not installed.
Ò
DO NOT
close base without a vise or top tool present
• Verify that the base is fully open by turning the socket adapter with a 6mm hex key
counter-clockwise until the hex key stops
Ò
DO NOT
over rotate - damage may occur
5. Align vise pull studs with pull stud pockets on base and seat squarely
• Pull studs should easily fit into the pull stud pockets. If not, ensure that
the base is in the fully open position and there are no obstructions.
• Lifters will hold vise approximately 2mm above base pads
• DO NOT
use a hammer or mallet to seat vise
6. Turn socket adapter clockwise with a 6mm hex key
• Top tool will seat securely to base
• DO NOT
tighten beyond MAX Torque — 20 Nm
7. The assembly ready for use.
BASIC OPERATION (CONT.)
