MAINTENANCE AND CLEANING
• Avoid unnecessary contact or immersion in water or water-based coolant
Note:
Machine coolant has some inherent lubrication properties and is often used as a substitute for grease.
If using water soluble coolant, maintain coolant concentration to the minimum recommendation from the
manufacturer to inhibit corrosion and pitting.
• Blow off top of base with air when vise or work-piece is changed
• Install plugs and caps when base is not in use
• When the base is in use, keep the caps in place on the unused holes unless they interfere with the vise.
• If base is to be stored long-term, spray or wipe with a rust inhibitor such as Acekote or Zerust
◦
If the base is exposed to large amounts of machining, grinding particles or clamping operation becomes
difficult, then refer to the Dynolock assembly instructions.
◦
When base is re-assembled:
Ò
Apply grease to any sliding or contact surfaces of the clamping mechanism
Ò
Use NLGI Grade 2 Li-based grease with MoS2 (MobilGrease XHP 322 Mine or similar)
ADDITIONAL INFORMATION
For assembly instructions and more, consult the DynoLock instructions by going to mate.com/wh or for fast access —
scan the QR code at right to download.
INSTRUCTIONS/
MAINTENANCE
