Page | - 8 -
© Copyright Mastip Technology Limited. Information subject to alteration. V3.51a www.mastip.com
Temperature Controller
METICOM TM10 Module
2. Wiring
3. Features
◆
Display unit: 3-digit red LED (PV)
◆
4-digit green LED (SV)
◆
Sensor type can be changed by shortcuts
◆
Remote standby control is optional
◆
Over-voltage protection
◆
Reverse of sensor and heater protection
◆
Short load protection
◆
Fuse blowout alarm
◆
Triac breakdown alarm
◆
Over load alarm
◆
Thermocouple open alarm
◆
Thermocouple reverse alarm
◆
Temperature high alarm
◆
Temperature low alarm
◆
Heater fault alarm
◆
Heating invalid alarm
◆
High alarm of ambient temperature
◆
High limit of load current
◆
High limit of output percentage
6) End soft start process: Press MODE (when boS=1).
7) Activate BOOST function: Press MODE (when boS=1, and soft start process end).
8) Change sensor type: Press DISP>9sec.
Parameter mode:
By pressingSET>3sec. in normal mode, the controller enters the parameter mode.
PV displays parameter name and SV displays the parameter’s value. In this mode, you can
1) Change the parameter value: Press
∧
、
∨
to modify the value, and press SETto save it, then the next parameter and its
