- 10 -
Picture 4
Dismount the gas tip of welding torch. Unscrew the flow drawing tip.
Connect the socket plug into the network. Turn on the main switch B1 (pic. 1) to position I.
Press button 10 (pic. 5) - the welding wire is lead into the torch without gas. The speed of the leading-in can be
adjusted with the potentiometer 8 (pic. 5). Press button 10 on control panel (or switch on torch) again to stop
lead-in of wire.
Before welding use separating spray in the space of gas tube and flow drawing tie. In that way you prevent adher-
ence of metal spatter and prolong the life of gas tube
ATTENTION!
During wire threading don´t aim the torch against eyes!
Panel of functions
Control and signal elements on the digital panel – description of functions:
1.
4T controls, tack welding, tack welding with delay.
The control lights are on, if these modes are active.
2.
FUNC button.
Individual modes can be selected with this button.
3.
DYNAMICS button
. By pushing this button the mode for arc hardness setting is entered. The hardness value is
then set with selector 8. By choosing a low value we get a softer arc and bigger weld penetration of the mate-
rial. By choosing a higher value we will get a bigger weld deposit. By choosing the correct arc dynamics selec-
tion we regulate spatter.
