EasyView 5 - User and Installation Manual
23
Event X
Command
Event-based command
Action to be taken by the Event X target.
The "Power save" command can be used
to set the EasyView 5 in standby mode.
Disabled
Disabled, State,
Lock,
Feedback 1-6,
Buzzer,
Power save,
Message 1-6
Event X Data Event 1 data controls the Event X
command, see section 6.8 for explanation.
Off
Off, On, Copy,
Copy Invert,
Toggle
6.8
Event data
The figure on the right shows an example of Input
(pulses) and Output (data) to explain the Event
Data.
On changes the status to On at the first signal.
Off changes the status to Off at the first signal.
Copy lets the status follow the input.
Copy Invert lets the status follow the opposite of
the input. Copy is used for dimming too by holding
the pulse switch pressed for a longer time.
Toggle changes the status at the first signal and
back at the second signal. It is used in
combination with a pulse switch.
Event Data
6.9
Configuring other devices
Monitoring and configuring other devices is possible by selecting a device in the EasyView 5 device
list, see section 6.2. Refer to the user manual of the connected device for an overview of all
available settings. Settings are stored in the memory of the selected device. This means that
switching off or disconnecting of the EasyView 5 will not affect the settings of the connected
devices. See section 6.6 to enable configuration of all connected devices.
