Improper connection of the equipment-grounding conductor can result in a risk of
electrical shock. Check with a qualified electrician or service person if you are in
doubt as to whether the outlet is properly grounded.
DO NOT
modify the plug provided with the burnisher. If it will not fit the
outlet, have a proper outlet installed by a qualified electrician.
NOTE:
In Canada, the use of a
temporary adaptor is not
permitted by the
Canadian Electrical Code.
This burnisher can be used in conjunction
with any of the ultra high speed chemical sys-
tems. It is mandatory, however, that the floor
be prepared as directed by the chemical
manufacturer. This will eliminate a possibility
of damage to floor due to the burnishers high
speed.
The burnisher is pre-set at the factory for
use with a 1" thick buffing pad
(1 shpd w/unit)
.
The rougher hair surface is preferred for
high luster floor finishing.
1.
Before operating this burnisher, check to
see that the buffing pad is properly centered
on driver and that center pad lock is tight on
pad.
2.
When operating the burnisher it
MUST
be kept moving, as holding machine station-
ary while running will result in damage to
floor and floor finish.
3.
Begin operating the burnisher at the clos-
est point to your electrical outlet and work
away from the outlet. This will prevent run-
ning over the electric cord.
4.
Never leave burnisher resting on buffing
pad for an extended period of time. This will
cause buffing pad to lose its normal shape,
causing wobbling or vibration and pad must
be replaced. Also, replace pad if glazed,
clogged, torn or shredded.
5.
The rear wheels on the 1500 RPM and
2000 RPM burnishers are factory-set for
low amp rating and high luster burnishing
with buffing pad. See instruction sheet.
6.
A carbon brush wear indicator warning
light is located on the motor canopy. When
lit, motor carbon brushes must be replaced
within 20 hours running time to prevent
damage to motor. See instruction sheet.
G
ROUNDING
M
ETHODS
O
PERATING
I
NSTRUCTIONS
This burnisher is NOT a low speed floor machine.
DO NOT use the burnisher for stripping or sanding of floors.
W
ARNING
:
C
AUTION
:
P
AGE
3
To avoid fire, DO NO use with a flammable or combustible
liquid to clean a floor.
W
ARNING
:
This burnisher is for use on a nominal 120
volt circuit, and has a grounding plug that
looks like the plug illustrated in (Fig A). A tem-
porary adaptor that looks like the adaptor
illustrated in (Fig B & C) may be used to con-
nect the plug to a 2-pole receptacle as
shown in (Fig A) if a properly grounded outlet
is not available.
The temporary adaptor should be used only
until a properly grounded outlet (Fig A)can be
installed by a qualified electrician. The green
color rigid ear, lug, or the like extending from
the adaptor must be connected to a perma-
nent ground such as a properly grounded
outlet box cover. Whenever the adaptor is
used, it must be held in place by the metal
screw (Fig C).
