MasterCraft Maximum Hawkeye Laser 055-6746-0, Руководство пользователя

Страница: 41 / 48

41
WARNING:
●
When cleaning the lower guard, unplug the saw from the power source to avoid
unexpected startup.
●
Do not use solvents on the guard. They could make the plastic “cloudy” and
brittle.
●
Periodically, sawdust will accumulate under the work table and base. This could
cause difficulty in the movement of the worktable when setting up a mitre cut.
Blow out or vacuum up the sawdust frequently.
●
When blowing sawdust, wear proper eye protection to keep debris from entering
eyes.
X. Maintenance (continued)
Lubricate the following as necessary:
Chop pivot: Apply light machine oil to
points indicated in illustration.
Central pivot of plastic guard: Use light
household oil (sewing machine oil) on
metal-to-metal or metal-to-plastic guard
contact areas as required for smooth,
quiet operation. Avoid excessive oil,
because sawdust will cling to it.
Link:
(actuates the lower guard
movement) may be oiled at the rear pivot,
greased at ball bearing contact, and oiled
where the link actuates the acetyl roller
of the lower guard, if the downward chop
motion is hard to start.
LUBRICATION (FIG. 42)
All of the motor bearings in this tool are lubricated with a sufficient amount of high-grade
lubricant for the life of the unit under normal operating conditions. Therefore, no further
lubrication is required.
Fig. 42

!
Add oil here
Add oil here
Add oil here and
on opposite side