22
WARNING:
To avoid injury from unexpected saw movement:
Before moving the saw, disconnect the power cord from the outlet and lock the
cutting arm in the lower position using the stop latch.
NOTE: The stop latch is for carrying or storing the tool. It is NOT to be used for
holding the saw while cutting.
●
Never carry the mitre saw by the power cord or by the switch handle.
Carrying the tool by the power cord could cause damage to the insulation or
wire connections, resulting in electric shock or fire.
●
To avoid injury from flying debris, do not allow visitors to stand behind the
saw.
●
Place the saw on a firm, level work surface where there is room for handling
and proper support for the workpiece.
●
Support the saw on a level work surface.
●
Bolt or clamp the saw to its support.
!
VIII. Assembly and adjustments (continued)
33.9° Right Bevel Adjustment (Fig. 19)
1. Set the mitre angle to 0°. Fully extend
both sliding fences.
2. Loosen the bevel lock handle (1).
3. Set the stop block (2) at 33.9°
position
by turning the lever (3) clockwise.
4. Using a combination square, check to
see if the blade is 33.9° to the table.
5. If the blade is not 33.9°
to the mitre table,
tilt the cutting arm to the left, loosen the
locknut (4) on the stop block (2), and turn
the bolt (5) in or out with a hex wrench
until the blade is 33.9° to the table.
Fig. 19
33.9° Left Bevel Adjustment (Fig. 20)
1. Set the mitre angle to 0°. Fully extend
both sliding fences.
2. Loosen the bevel lock handle (1).
3. Set the stop block at 33.9° position by
turning the lever (2) clockwise.
4. Using a combination square, check to
see if the blade is 33.9° to the table.
5. If the blade is not 33.9°
to the mitre
table, tilt the cutting arm to the right,
loosen the locknut (3) on the stop block
(5), and turn the bolt (4) in or out with
a hex wrench until the blade is 33.9° to
the table.
Fig. 20
1
4
3
2
5
1
2
3
4
5
Содержание Maximum Hawkeye Laser 055-6746-0
