MasterCraft 55-6847-0, Руководство по эксплуатации, Страница: 6 / 23

a negative hook angle.
IMPORTANT: Do not use thin-kerf blades.
Thin-kerf blades can deflect and contact the guard,
which can cause possible injury to the operator.
Do not
operate the Compound Mitre Saw until it is completely assembled and installed according to
these instructions.
If not
thoroughly familiar with the operation of Compound Mitre Saws, seek guidance from a
supervisor, instructor, or other qualified person.
Always
hold the work firmly against the fence and table. Do not perform any operation free hand;
use a clamp or vise whenever possible.
Keep hands
out of the path of the saw blade. If the work piece causes the hands to be within the
“no hands” zone (3 in. (7.6 cm) from blade), the work piece should be clamped in place before
making the cut.
Be sure
that the blade is sharp, runs freely, and is free of vibration.
Allow
the motor to come up to full speed before starting a cut.
Keep the motor’s air slots clean
and free of chips or dust.
Always make sure
that all adjusting knobs are tightened before cutting, even if the table is
positioned in one of the positive stops.
Be sure
that both the blade and the flange are clean and the arbour bolt is tightened securely.
Use
only blade flanges specified for this saw.
Never
use blades larger or smaller in diameter than 10 inches (25.4 cm).
Never
apply lubricants to the blade while it is running.
Always
check the blade for cracks or damage before operation. Replace a cracked or damaged
blade before further use.
Never
use blades recommended for operation at less than 5000 RPM.
Use the blade guards
at all times.
Always
keep the blade guards in place.
Never
reach around the saw blade.
Make sure
that the blade is not contacting the work piece before the ON/OFF switch is turned ON.
IMPORTANT:
After completing the cut, release the power switch and wait for the blade to stop
before returning the saw to the raised position.
Make sure
that the blade has come to a complete stop before removing or securing the work piece,
changing the work-piece angle, or changing the angle of the blade.
Never
cut metals or masonry products with this tool. This Compound Mitre Saw is designed for use
on wood and wood-like products.
Never
cut small pieces. Keep hands outside the no-hands zone: at least 3 in. (7.6 cm) from the
blade.
Provide
adequate support to the sides of the mitre table for long work pieces.
Never
use the Compound Mitre Saw in an area with flammable liquids or gases.
Never
use solvents to clean plastic parts. Solvents could possibly dissolve or otherwise damage the
material.
Shut off
the power and unplug the tool before servicing or adjusting the tool.
Disconnect
the saw from the power source and clean the tool when finished using it.
Make sure
the work area is clean before leaving the tool.
Should any part
of this Compound Mitre Saw be missing, damaged, or fail in any way, or should
any electrical component fail to perform properly, shut off the power switch and remove the plug
from the power-supply outlet. Replace missing, damaged, or failed parts before resuming operation.
6