MasterCraft 054-7947-8, Инструкция по эксплуатации

Страница: 15 / 24

headline bars
continuation tabs
notes
warnings
headline bars
continuation tabs
notes
warnings
headline bars
continuation tabs
notes
warnings
15
ADJUST THE GRINDING/CUTTING GUARD
(fig 5)
1. Remove the battery pack from the angle grinder.
2. Press the guard-adjusting lever and hold it to loosen
the guard.
3. Rotate the guard to the desired position and make
sure that the lever lines up with the notch on the
guard.
4. Release the guard-adjusting lever to lock the guard;
verify that the lever secures the guard.
MOUNT THE GRINDING WHEEL (fig 6-7)
1. Remove the battery pack from the angle grinder.
2. Make sure that the grinding guard is securely in
place. Depress the spindle-lock button. Loosen
the outer flange with the supplied wrench while
holding the spindle-lock button down (fig 7).
3. Place the inner flange on the spindle; make sure
that the inner flange is positioned so that the shape
of the opening in the flange corresponds with the
shape at the base of the spindle.
4. Place the grinding wheel on the spindle.
5. Thread the outer flange on the spindle with the flat
side of the flange facing up, making sure that the
opening in the grinding wheel is positioned around
the raised portion of the outer flange (fig 6).
6. Press the spindle-lock button to prevent movement
of the spindle.
7. Keep the spindle-lock button depressed; tighten the
threaded outer flange by turning it clockwise with
the wrench (fig 7).
OPERA
TING INSTRUCTIONS
fig 7
Spindle-lock
button
WARNING!
• Never use a grinding wheel with a rated speed lower than the speed shown on the grinder nameplate.
• Use only Type 27 grinding wheels with the diameter of 4 1/2” (115 mm) and thickness of 1/4” (6 mm), such
as the one provided with this product.
FPO
fig 5
Guard-
adjusting lever
Notch on the
guard
fig 6
Outer flange
Inner flange
Spindle
Grinding
wheel