MasterCraft 054-6908-8, Инструкция по эксплуатации

Страница: 9 / 21

FIXED-BASE ROUTER - 054-6908-8 FIXED-BASE ROUTER - 054-6908-8
15 16
WARNING!
ALWAYS
turn the motor off and unplug the router from the power source before making any
adjustments or installing accessories. Failure to turn the motor off and unplug the router could
result in accidental starting, which can cause serious personal injury.
1. Turn the motor off, and unplug the tool from the power source.
2. Place the fixed base on a flat surface.
3. With the back of the fixed base facing the operator, loosen the motor clamp (A) (fig 4).
4. Press the Rough-adjustment Knob (B) to disengage the gears (C) while aligning the motor housing’s
key strip (D) with the key strip slot (E) in the fixed base (fig 4).
5. When the motor’s key strip is aligned and engaged with the base’s key strip slot, slide the motor
down into the fixed base.
6. The motor will now slide up or down when the Rough-adjustment knob is pressed in, permitting
rough adjustments.
7. After all adjustments are made, tighten the motor clamp securely.
OPERA
TING INSTR
UCTIONS
Removing the motor from
the base
1. Turn the motor off, and unplug the tool from
the power the source.
2. Place the router (fixed base/motor housing) on
a flat surface.
3. With the back of the router facing the operator,
loosen the motor clamp (A) (fig 4).
4. Push the Rough-adjustment knob (B) to
release the motor housing key strip from the
gear in the base while lifting the motor free of
the base (fig 4).
5. Set the motor upside down on its top cap, with
the collet pointing up, and remove the cutter
bit.
6. Store the motor and base in the case when the
router is not being used.
WARNING!
ALWAYS remove cutter bits from the collet when the router is not being used. Leaving bits
installed could result in an accident causing serious personal injury.
WARNING!
ALWAYS turn the motor off and unplug the router from the power source before making any
adjustments or installing accessories. Failure to turn the motor off and unplug the router could
result in accidental starting, which can cause serious personal injury.
Installing the router motor in the base
WARNING!
NEVER
use the router motor without installing it into an approved fixed or plunge base.
Failure to do so could result in serious personal injury and damage to the motor.
NOTICE:
Before installing the motor housing in the fixed base, install the collet and router cutter bit in
the motor housing. See
“INSTALLING AND REMOVING THE CUTTER BIT”
.
OPERA
TING INSTR
UCTIONS
fig 4
D
E
B
C
A