MasterCraft 054-6908-8, Инструкция по эксплуатации

Страница: 16 / 21

FIXED-BASE ROUTER - 054-6908-8 FIXED-BASE ROUTER - 054-6908-8
29 30
Dust collection with a vacuum
adaptor
(fig 18)
WARNING!
ALWAYS turn the motor off and unplug
the router from the power source before
making any adjustments or installing
accessories. Failure to turn the motor
off and unplug the router could result
in accidental starting, which can cause
serious personal injury.
A vacuum adaptor is included with this router. The adaptor is sized to accept a 1-1/4" (3.2 cm) vacuum
hose adaptor (not included).
To attach the adaptor onto the fixed base, position and secure it to the back of the base using the two
screws (included), as shown in fig 18.
General
Only the parts shown on the parts list are intended for repair or replacement by the customer. All other
parts represent an important part of the double-insulation system.
Toll-free Helpline – 1-800-689-9928.
WARNING!
To ensure safety and reliability, all repairs should be performed by a qualified service
technician.
WARNING!
For personal safety, always turn the switch off and unplug the router motor from the power
source before performing any maintenance or cleaning.
WARNING!
If the supply cord is damaged, it must be replaced by a specially prepared cord available
through the service organization.
It has been found that electric tools are subject to accelerated wear and possible premature failure
when they are used to work on fibreglass, wallboard, spackling compounds or plaster. The chips and
grindings from these materials are highly abrasive to electrical tool parts, such as bearings, brushes,
commutators, etc. Therefore, it is not recommended that this tool be used for extended work on any
fibreglass material, wallboard, spackling compound or plaster. During any use on these materials, it is
extremely important that the tool is cleaned frequently by blowing with an air jet.
WARNING!
Always wear safety goggles or safety glasses with side shields during power tool
operations, or when blowing dust. If the operation is dusty, also wear a dust mask.
2 screws included
fig 18
MAINTENANCE
OPERA
TING INSTR
UCTIONS