MasterCraft 054-6821-2, Инструкция по эксплуатации

Страница: 19 / 28

headline bars
continuation tabs
notes
warnings
headline bars
continuation tabs
notes
warnings
headline bars
continuation tabs
notes
warnings
19
headline bars
continuation tabs
notes
warnings
headline bars
continuation tabs
notes
warnings
headline bars
continuation tabs
notes
warnings
MAINTENANCE
MAINTENANCE
Before cleaning or performing any maintenance, verify that the router has been disconnected from the
power supply. Keep all ventilation openings clean. Avoid using solvents when cleaning plastic parts.
Most plastics are susceptible to damage from various types of commercial solvents. Use a clean cloth
to remove dirt, oil, and grease.
After using the router for a period of time, some wood dust may enter into the base or collet; it is best
to use compressed air or a brush to clean the dust.
REPLACEMENT OF CARBON BRUSHES
(fig 16)
1. Disconnect the plug from the power supply.
2. Replace both carbon brushes when either has less
than 1/4” (6.4 mm) length of carbon remaining, or if
the spring or wire is damaged or burned.
3. Using a slotted screwdriver, remove the black plastic
cap on each side of the router motor and carefully
withdraw the spring-loaded brush assemblies.
4. Keep brushes clean and sliding freely in their guide
channels.
5. Insert new brush assemblies into the guide channels with the carbon part going in first, being certain to fit
the two metal “ears” into their slots in the channel. Remember to replace both end caps after inspecting or
servicing the brushes.
6. Tighten the caps snugly, but do not overtighten. The router should be allowed to “run in” (run at no load
without a cutter bit) for 5 minutes before use, to seat the new brushes properly.
FPO
WARNING!
• Do not let brake fluids, gasoline, petroleum-based products, penetrating oil, etc., come into contact with
plastic parts. They contain chemicals that can damage, weaken, or destroy plastic.
• To ensure safety and reliability, all repairs should be performed by a qualified service technician.
• For your safety, always turn off the switch and unplug the router motor from the power source before
performing any maintenance or cleaning.
fig 16
NOTICE:
To reinstall the same brushes, make sure that the brushes go back in the same way they came out. This will avoid
the need for a break-in period.
Carbon brush
Ears
Cap