MasterCraft 054-1245-4, Руководство пользователя

Страница: 8 / 26

8
Before attaching the grinding disc, inspect
it for visible defects. If it is cracked,
chipped or warped do not install it.
Use only grinding discs in compliance with
ANSI Standard B7.1 and rated for a speed
greater than 6,500 RPM.
Do not remove the soft paper in the centre
of the grinding disc.
NOTE: If this paper has been previously
removed, insert some soft rubber or paper
between the grinding disc and the disc
flange to prevent damage to the grinding
disc.
Do not alter or enlarge the centre hole of
the grinding disc as this could result in
breaking it.
Do not over tighten the clamp nut on the
grinding disc. Excessive tightening may
cause the disc to crack and possibly
shatter during operation.
Do not use the grinder if the disc flange or
clamp nut is missing or if the spindle is
bent.
Check to make sure and any extension
cords are clear of the area to be cut.
Contact with ”live” wires could shock the
operator or cause a fire.
Always hold the grinder securely with two
hands while working and at all times when
it is running.
Never turn the grinder ON with the grinding
disc or any rotating parts touching the work
surface.
Never cover the air vents in the motor
housing with your hands while operating
the grinder.
SPECIFIC SAFETY RULES