www.desatech.com
120942-01E
7
eLecTricaL SUPPLy
This heater requires an electrical supply to
be furnished by the user. The electrical outlet
should have the following ratings:
120 volts (+/- 10%), 60 Hertz, 15 Amps
Ground Fault Interrupter (GFI)
The heater uses the ground circuit to prove the
flame by sending a low voltage (40 mV DC)
signal back to the DSI control. If the ground
supply is not correctly wired or is missing, the
heater will not work.
ExTENSION CORDS
Extension cords used to connect the heater
must be 3 prong, grounded type of proper
gauge. Extension cord requirements are as
follows:
• Up to 100 feet (30 m), use 16 AWG rated
cord
• 101 to 200 feet (32 to 60 m), use 14 AWG
rated cord.
OPERATION WITH PORTAbLE
GENERATOR
WARNING: before operating
heater or any appliance from a
portable generator, verify that
generator has been properly con-
nected to earth ground. Improper
grounding or failure to ground
generator can result in electro-
cution if a ground fault occurs.
Refer to owner’s manual supplied
by generator manufacturer for
proper grounding procedures.
The operating voltage range of the heater is
108 to 132 Volts (120 Volts +/- 10%). Prior
to plugging heater into generator the output
voltage should be verified (if generator is
equipped with the automatic idle feature, the
output voltage should be measured with the
generator running at full speed). If the voltage
does not measure in this range the heater
should not be plugged into the generator.
UnPacking
1. Remove all packing items applied to
heater for shipment. Keep plastic cover
caps (attached to inlet connector and
hose/regulator assembly) for storage.
2. Remove all items from carton.
3. Check all items for shipping damage. If
heater is damaged, promptly inform dealer
where you bought heater.
