www.desatech.com
120193-01A
10
inSTaLLaTion
2.. Connect. fuel. gas. connector. fitting. on.
hose/regulator. assembly. to. propane.
tank(s).(see.Figure.7)..Turn.counterclock-
wise.into.threads.on.tank.valve..Tighten.
firmly using wrench.
.
IMPORTANT:
.Tighten.regulator.with.vent.
pointing. down.. Pointing. vent. down. pro-
tects.regulator.from.weather.damage.
3.. Connect. hose. to. inlet. connector. (see.
Figure 8). Tighten firmly using a wrench.
.
IMPORTANT:
Extra hose or piping may be
used.if.needed..Install.extra.hose.or.piping.
between. hose/regulator. assembly. and.
propane.tank..You.must.use.the.regulator.
supplied.with.heater.
4.. Open.propane.supply.valve.on.propane.
tank(s).slowly.
.
Note: If not opened slowly, excess flow
check valve on propane tank will stop gas
flow. If this happens, close propane supply
valve and open again slowly.
5.. Check.all.connections.for.leaks..Correct.
all.leaks.
Figure 7 - Regulator With Vent Pointing
Down
Hose
Regulator
Vent.
(pointing.
down)
Fuel.Gas.
Connector
Supply.Valve
Propane.
Tank
Figure 8 - Hose and Inlet Connector
Hose
Inlet.
Connector
WARNING: Review and un-
derstand the warnings in the
Safety
section, page 2. They are
needed to safely operate this
heater. Follow all local codes or
in the absence of local codes,
with the
Standard for Grand-
stands, Folding and Telescopic
Seating, Tents and Membrane
Structures NFPA 102
and the
Standard for Storage and Han-
dling of Liquiefied Petroleum
Gases ANSI/NFPA 58
.
WARNING: Test all gas piping
and connections for leaks after
installation or servicing. Never
use an open flame to check for a
leak. Apply a noncorrosive leak
detection fluid to all joints (avail
-
able at local plumbing supply
stores). bubbles forming show a
leak. Correct all leaks at once.
1.. Provide. propane. supply. system. (see.
Propane Supply
,.page.6).
