NEVER LEAVE HEATER UNATTENDED WHILE CONNECTED TO
A POWER SOURCE
© 2020, Pinnacle Climate Technologies,Inc
Electric Radiant Workshop Heater
3
Assembly
Operation
Assembly
1. Attach “L” Bracket to Cross Brace with Three (3)
5/8" Socket Screws.
2. Attached both Side Braces to the Cross Brace
with Two (2) 5/8" Socket Screws on each.
3. Attached Heater Head to Side Braces with 5/8"
Socket Screws, Two (2) on each side.
4. Finally, attach the completed Heater Head
assembly to Tripod base with Two (2) 2
3
/
16
"
Socket Screws.
5. Make sure all Screws are tight.
Operation
1. Position the heater so that it stands upright
on a firm, level surface and at a safe distance
from wet environments and flammable
objects.
2. Connect the heater to the proper electrical
power.
3. Switch the power button on.
Automatic Overheat Safety Control
– This heater is equipped with overheat
protection circuit. When a potential overheat
temperature is reached, the system will
automatically shut the heater
Maintenance
Cleaning and Maintenance
– Before cleaning the appliance, disconnect it
from the outlet and let it cool down.
– The enclosure is easy to get dirty. Wipe it
often with a soft sponge. For very dirty parts,
wipe with a sponge dipped in < 122°F water
and mild detergent, then dry the heater
enclosure with a clean cloth. Be careful not to
let the water enter the inside of the appliance
– In order to protect the enclosure, do not
splash water onto the heater, and never
use a solvent like gasoline, isoamyl acetate,
toluene, etc. to clean the heater.
Tripod Base
2
3
/
16
" Socket Screws
Wing Nuts
5/8" Socket
Screws
Heater
Head
Cross Brace
Side Brace
“L” Bracket
