NEVER LEAVE HEATER UNATTENDED WHILE CONNECTED TO
A POWER SOURCE
© 2020, Pinnacle Climate Technologies,Inc
Electric Radiant Workshop Heater
Safety Information
1
Turn the electrical power off at the electrical panel board
(circuit breaker or fuse box) and lock or tag the panel board door
to prevent someone from turning on the power while you are
working on the heater. When using electrical appliances, basic precautions should always
be followed to reduce the risk of fire, electric shock and injury to persons, including the
following:
WARNING
RISK OF ELECTRIC
SHOCK!
WARNING
Read all
instructions before
using this heater.
WARNING
– Extreme caution is necessary when any heater is
used by or near children or invalids.
– This heater is not intended for use in bathrooms,
laundry areas and similar indoor locations. Never
locate heater where it may fall into a bathtub or
other water container.
– Always locate heater on a stable and level
surface.
– Do not place the heater against paperboard or
low-density fiberboard surfaces.
– Avoid using an extension cord because the
extension cord may overheat and cause a risk of
fire.
– ALWAYS use only the electrical power (voltage
and frequency) specified on the model plate of the
heater.
– ALWAYS use only three-prong, grounded outlet
and extension cord.
– ALWAYS unplug the heater when not in use.
– Keep all combustible materials away from
this heater
Minimum Clearance From Combustibles
MH-410TCF-120
Front
1.5m / 5 ft.
Top
1.5m / 5 ft.
Sides
1.5m / 5 ft.
Rear
1.5m / 5 ft.
Look for this icon throughout the manual for helpful tips on how to use and
clean your Electric Radiant Workshop Heater.
