Pinnacle Products International, Inc. Propane Forced Air User’s Manual
Page 3
General Safety Information
Indicates an im minen tly hazardous situa-
tion which, if not avoided, WILL result in
death or serious injury.
Indicates a poten tially hazardous situation
which, if not avoided, COULD result in
death or serious injury.
Indicates a poten tially hazardous situa tion
which, if not avoided, MAY result in minor
or moderate injury.
Consumer: Retain these instructions for future reference.
Improper use of this heater can result in
serious injury or death from burns, fire,
explosion, electrical shock and /or carbon monoxide
poisoning.
This heater is designed and approved for use as a construction
heater in accordance with ANSI Z83.7a/CSA 2.14a-2007. Other
standards govern the use of fuel gases and heating products for
specific uses. Your local authority can advise you about these.
The primary purpose of construction heaters is to provide tempo-
rary heating of buildings under construction, alteration, or repair.
Properly used, the heater provides safe economical heating.
Products of com bustion are vented into the area being heated.
Not for use with ductwork.
Do not operate this heater until you read and
thoroughly understand the safety and oper-
ating instructions.
Combustible by-prod ucts produced when
using this product contain carbon monox-
ide, a chemical known to the State of California to cause
cancer, birth defects, or other reproductive harm.
The hose assembly shall be pro tected
from traffic, building material and contact
with hot surfaces both during use and while in storage
.
IMPORTANT:
Read this User's Manual carefully and completely
before attempting to operate or service this heater. Improper use
of the heater can cause serious injury or death from fire,
explosion and carbon monoxide poisoning.
Every possible circumstance that may involve a hazard cannot be
anticipated. The warnings in this manual and at tach ed to the unit
are therefore not all-inclusive. If a procedure, work method or oper-
ating technique not specifically recommended by Pinnacle is used,
you must be sure it is safe for you and others. You should also
insure that equipment will not be damaged or made unsafe by the
operating or maintenance method you choose.
CHECK WITH YOUR LOCAL FIRE SAFETY AUTHORITY IF YOU
HAVE ANY QUESTIONS ABOUT APPLICATIONS. This heater is
designed and approved for use as a construction heater under
ANSI Z83.7a/CSA 2.14a-2007.
Other standards govern the use of fuel gasses and heat produc-
ing products in specific applications. Your local authority can advise
you of these.
This is a direct-fired, forced-air construc tion heater for either
indoor or outdoor use. It's intended use is primarily for the
temporary heating of buildings under construction, alteration or
repair. All of the products of combustion generated by this heater
are forced through the heater and released into the area being
heated. This heater operates at approx imately 98%+ combustion
efficiency, but still produces small amounts of carbon monoxide.
Humans can tolerate small amounts of carbon monoxide for short
periods. Carbon monoxide can build up in a heated space, and
failure to provide adequate ventilation could result in poisoning or
death.
You must provide the propane gas and cylinder(s). Use this
heater only with a propane vapor withdrawal supply system.
Refer to Chapter 5 of the Standard for Storage and Handling of
Liquefied Petroleum Gas , ANSI/NFPA 58. Your local library or
fire department will have this booklet.
IMPORTANT SAFETY INFORMATION
- Children should be kept away.
- Always maintain proper clearance from combustible materials.
Minimum clearance should be:
Sides - 24” Top - 36” Front - 72”
- Heater must be placed on level and solid footing.
- Never place anything, including clothes or other flammable items
on heater.
- Do not modify heater, or operate a heater that has been
modified.
- Adequate clearance for accessibility, combustion and ventilation
(air supply) must be maintained at all times when heater is oper-
ating.
- Service and repair should be performed by a qualified service
person. The heater should be inspected before each use, and at
least annually by a qualified person. More frequent cleaning may
be required as necessary. Do not service heater while hot or
operating.
- Never connect heater to an unregulated gas supply.
- Use only the electrical/power cord specified. Electrical and
grounding connection must comply with National Electrical
Code - ANSI/NFPA 70 (USA) and CSA C22.1 Canadian
Electrical Code, Part 1 (Canada).
- To prevent injury, always wear gloves when handling heater.
Never handle an operating or hot heater, as severe burns may
result.
- Use heater in accordance with all local codes. In the absence
of local codes, refer to The National Fuel Code, ANSI Z223.1.
WARNING
CAUTION
WARNING
DANGER
DANGER
WARNING
WARNING
WARNING
Not for home or recreational vehicle use.
Fire, burn, inhalation, and explosion
hazard. Keep solid combustibles such as
building materials, paper, or cardboard, at a safe distance
away from heater as recommended by the instructions.
Never use the heater in spaces which do or may contain
volatile or airborne com bustibles or products such as
gasoline, solvents, paint thinner, dust particles, or unknown
chemicals.
WARNING
WARNING
Propane
Forced Air Heaters
NEVER LEAVE HEATER UNATTENDED
WHILE BURNING, CONNECTED TO A
POWER SOURCE, OR WHILE
CONNECTED TO A FUEL SOURCE
