NEVER LEAVE HEATER UNATTENDED WHILE BURNING,
CONNECTED TO A POWER SOURCE, OR WHILE
CONNECTED TO A FUEL SOURCE
© 2018 Pinnacle Climate Technologies, Inc.
Propane Forced Air Heater User’s Manual
4
ALWAYS use the electrical power (voltage and fre-
quency) specified on the model plate of the heater.
ALWAYS use only 14 AWG or better extension cord.
ALWAYS unplug the heater when not in use.
ALWAYS install the heater so that it is not directly ex-
posed to water spray, rain, dripping water, or wind.
–
Use heater in accordance with all local codes.
In the absence of local codes, refer to The
National Fuel Code, ANSI Z223.1.
–
This heater is shipped from the factory
for use with propane (LP) gas only.
Do not
convert to any other gas. Installation must
conform to local codes, or in their absence,
with the standard for the Storage and Handling
of Liquefied Petroleum Gases ANSI/NFPA 58
and the Natural Gas and Propane Installation
Code CSA B149.1.
–
Gas supply connections should be checked by
using a 50/50 soap and water solution. Never
use a flame to check for gas leaks.
–
Locate LP cylinder at least 6 feet (10 ft. in
Canada) from the heater, and do not direct
heater discharge towards the LP cylinder
unless it is at least 20 feet from the heater.
–
Use only the regulator and hose assembly
provided with this heater. Inspect the
regulator/hose assembly prior to each use of
the heater. If there is excessive abrasion or
wear, or if the hose is cut, replace it with the
proper assembly shown in the parts list, prior
to using the heater.
Manifold, Minimum, and Maximum Supply Pressure
MH-375T-GFA-A
Man.
7–10 PSI
Min.
23 PSI
Max.
Bottle Pressure
SAFETY INFORMATION (CONT.)
The hose assembly shall be
pro tected from traffic, building
material and contact with hot surfaces both dur-
ing use and while in storage.
WARNING
1. Remove all packing items applied to heater for
shipment. Keep plastic cover caps attached to
inlet connector and hose / regulator assembly
for storage.
2. Remove all items from carton
3. Check all items for shipping damage. If the
heater is damaged, promptly inform dealer
where you purchased the heater.
The Propane (LP) gas pressure
regulator and hose assembly
supplied with the heater must be used without
alteration.
CAUTION
UNPACKING
X
XXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXX
X
X
X
X
X
XXXXXXXXXX
RISK OF FIRE! DO NOT POSITION HEATER IN A DOWNWARD ANGLE. ALWAYS
LOCATE HEATER ON A STABLE AND LEVEL SURFACE (SEE FIGURE 1)!
WARNING
RISK OF ELECTRIC SHOCK!
Figure 1
For use with propane (LP)
gas only.
WARNING
Electrical Grounding In-
structions: This appliance is
equipped with a three-prong (grounding) plug
for your protection against shock hazard and
should be plugged directly into a properly
grounded three-prong receptacle.
WARNING
WARNING
