13
EN
If during use, the belt continues to move toward one side, adjustments are
necessary. The procedures are as below:
▲
First set speed at lowest position.
▲
Second check the belt shifts to which side.
If the belt shifts to right, tighten the right bolt and loosen the left bolt by
using Hexagonal Wrench, until the belt is centered itself; If belt shifts to left,
tighten the left bolt and loosen the right bolt by using 6mm Hexagonal Wrench,
until the belt is centered. When adjusting the belt using the Hexagonal Wrenches,
it is important to adjust the belt in half turn increments. Over adjusting the belt
can cause damage to the mat.
5. TROUBLE SHOOTING
This treadmill is designed in a way that in the event of an electrical fault, the
machine will turn off automatically to prevent any injuries to the user and to
prevent damage to the machine (i.e. motor).
When the treadmill behaves erratically, simply reset the treadmill by turning the
power switch off, waiting for 1 minute then turning the power button back on.
If, after you have reset the treadmill, it is still not running correctly, please run
the self-checking analyse (please refer to Self-Checking) to distinguish what
type of error problem the machine is encountering.
5.1 Alarm signals
E0: Safety key not in the position
Put the safety key in the position.
E1: No feedback from controller or speed sensor
5.
Check the condition of cables and ensure that all plugs are connected
between the motor controller and display.
Before attempting any work on the treadmill, ensure that the power is
off and the plug is removed from the power point.
Do not use extension leads as it may lead to power decrease and failure.
