12
EN
3.
Feel the back surface of the running mat.
If the surface is slick when touched, then no further lubrication is needed.
If the surface is dry to the touch, apply a suitable silicone lubricant.
We recommend you use a silicone based spray to lubricate your Lifespan
Treadmill. This Can be purchased from your local sports Retailer or a local
hardware store.
4.5 Belt Adjustment
Belt Tension Adjustment
-It is very important for joggers and runners in order
to provide a smooth, steady running surface. Adjustment must be made from the
right and left rear roller in order to adjust tension with the Hexagonal Wrench
provided in the parts package. The adjustment bolt is located at the end of the rails
as noted in diagram below:
Note: Adjustment is through the small hold on the end caps.
Tighten the rear roller only enough to prevent slippage at the front roller. Turn both
the right and left bolt clockwise reasonably and inspect for proper tension. When an
adjustment is made to the belt tension, you must also make a tracking adjustment
to compensate for the change in belt tension.
DO NOT OVERTIGHTEN - Over tightening will cause belt damage and premature
bearing failure.
4.6 Belt Tracking Adjustment
This treadmill is designed to keep the belt reasonably centered while in use. It is
normal for some belts to drift near one side while the belt is running with no one
on it. After a few minutes of use, the belt should have a tendency to center itself.
Left bolt
Right bolt
