Master Air Track MAS-B860, Руководство по установке

Страница: 10 / 12

EN
equipment on a slope greater than 5%.
•
Do not bring any sharp items on or close to the AirProduct.
•
Do not jump or land closer than 20 cm to a valve.
•
Assure that the AirProduct has sufficient air pressure to avoid injury. Recommended air pressure level s
can be found in this user manual.
•
Do not use the AirProduct without using landingmats on both ends. For safety reasons, also put landing mats on
the sides.
•
The area on which the AirProduct is placed must be clean, dry, flat and free of obstacles.
•
Always set up the AirProduct in the same area where you will be using it. When changing the location, do
not drag the AirProduct over the surface but carry it by the handles.
•
Do not use the AirProduct in humid areas, electrocution may occur.
•
Do not use the AirProduct in the rain. While inflating the equipment, electrocution may occur and also the
surface will be slippery which can cause injuries.
•
When setting up the AirProduct outdoor, use a groundsheet to avoid damaging the AirProduct.
•
Never pack, store or transport the AirProduct when it is wet.
•
The AirProduct is cleaned with water and soft soap. Do not use industrial cleaning products.
•
Never use a damaged AirProduct.
•
Never leave an AirProduct outside unattended and keep the air pressure under the maximum values
described in this guide.
•
Be aware that AirProducts are not designed as landing mats.
Set - up
Please make sure you have read the safety instructions before proceeding to set - up your AirProduct.
1. Unfold the board from the packa ging.
Pick the right location for the AirProduct. To prevent damage, make sure there is no debris in the area. If you
’
re
using the AirProduct outside, always use a ground cover.
2. Valve operation
Follow the instructions below for valve operation and correct inflation and deflation procedures.
The board’s inflation valve is located near the nose of the board. To close off the valve for inflation, make sure
that the center valve pin is in the “UP” position. If it is in the “DOWN” position, press the valve pin to “UP”
position.
To open the valve for deflation, press down on the valve pin (need not to turn it), make sure that the center
valve pin is in the “DOWN” position,
Be careful of any sand or debris around the valve area when deflating as small particles could become
airborne with the release of the air pressure.
Always lock the valve cover over the valve stem when in use. This will prevent accidental air release and
entrance of any particles into the air chambers.