9
Control Valve Timer Settings:
Note:
The control valve is set at the factory. You only need to set
the time of day, hardness and regeneration time if required, which is
preset at 2 am.
Time of Day Setting
1) Press the CLOCK button. The screen will show the Time of
Day in blinking numbers.
2) To change the Time of Day, press CLOCK, use the UP and
DOWN arrows to set the Hour.
3) To change the Minutes, press CLOCK, use the UP and
DOWN arrows to set the Minutes
4) Press the CLOCK button.
Hardness Setting (the factory default is 10)
1) Press the NEXT and UP arrow , hold for 3 seconds. The
screen will show the Hardness as grains per gallon in blinking
numbers.
2) To change the number, use the UP or DOWN arrows.
3) Press the NEXT button.
If water was tested by Master Water Conditioning, follow
recommendations on water analysis, for hardness setting. If
tested by an independent lab, assume 5 ppm of
uranium/nitrate = 1 gpg of hardness.
For MP-CST Units Only:
assume 1 ppm of tannin = 15 gpg of
hardness.
Use whatever gpg setting is higher for the appropriate unit.
Regeneration Day Override Setting (the factory default is 7)
1) The screen will show the Regeneration Day Override in
blinking numbers.
2) To change the number, use the UP or DOWN arrows.
3) Press the NEXT button.
Time of Regeneration Setting (the factory default is 2 AM)
1) The screen will show the Time of Regeneration in blinking
numbers.
2) If Regeneration time change is desired, use the UP and
DOWN arrows to set the Hour.
3) To change the Minutes, press NEXT, use the UP and DOWN
arrows to set the Minutes
4) Press the NEXT button.
