13
charger. If the LED status reads “defective” a second time, try charging a
different battery pack.
2. If a different battery pack charges normally, dispose of the defective
battery pack (see Maintenance section).
3. If a different battery pack also indicates “defective,” the charger may be
defective.
BATTERY CHARGING
If the battery pack is being charged within a normal surrounding temperature
range (50°F to 104°F), the green LED will begin flashing and the red LED will
be off. The battery pack will reach a full charge in 30 minutes.
BATTERY FULL
When the battery is fully charged, the green LED Light on the charger will be
on and the red LED light will be off.
NOTE:
The battery pack will fully charge, but will not overcharge, if left on the
charger.
NOTE:
Charger may warm with several continuous charge cycles. This is part
of the normal operation of the charge. Charge in a well ventilated area.
TO ATTACH BATTERY PACK (Fig. 4)
1. Make sure that the worklight is
“OFF”.
2. Align the raised rib on the battery
pack with the grooves of the
worklight, and then attach the
battery pack to the worklight.
NOTE
: Make sure that the latch on
the battery pack snaps into place and
that the battery pack is secured to the
tool before beginning operation.
TO DETACH BATTERY PACK (Fig. 4)
1. Depress the battery release buttons located on the both sides of the
battery pack to release the battery pack.
2. Pull the battery pack out and remove it from the tool.
DET
ACH
ATT
ACH
Fig. 4
