8
Use of an attachment not recommended or sold by the battery-charger
manufacturer may result in a risk of fire, electric shock or injury to persons.
Do not abuse the cord or charger. Never use the cord to carry the charger.
Do not pull the charger cord to disconnect the plug from receptacle.
Damage to the cord or charger could occur and create an electric shock
hazard. Replace damaged cords immediately.
Make sure that the cord is located so that it will not be stepped on, tripped
over, come in contact with sharp edges or moving parts, or otherwise
subjected to damage or stress.
This will reduce the risk of accidental falls,
which could cause injury and damage to the cord, which could then result
in electric shock.
Keep the cord and charger from heat to prevent damage to the housing or
internal parts.
Do not allow gasoline, oils, petroleum-based products, etc. to come in
contact with plastic parts. These materials contain chemicals that can
damage, weaken, or destroy plastic.
An extension cord should not be used unless absolutely necessary. Use of
an improper extension cord could result in a risk of fire and electric shock.
If an extension cord must be used, make sure that:
The pins on plug of extension cord are the same number, size and shape
as those of the plug on charger.
The cord is properly wired and in good electrical condition
The size is large enough for AC ampere rating of charger as specified below:
The Cord Length (Feet) 25’ 50’ 100’
Cord Size (AWG) 16 16 16
NOTE:
AWG = American Wire Gauge
Do not operate the charger with a damaged cord or plug,
which could
cause shorting and electric shock. If damaged, have the charger repaired or
replaced by an authorized service technician at an approved Service Center.
Do not operate the charger if it has received a sharp blow, been dropped,
or has otherwise been damaged in any way. Take it to an authorized
service technician at an approved Service Center for an electrical check
to determine if the charger is in good working order.
Do not disassemble the charger. Take it to an authorized service
technician at a Service Center when service or repair is required.
Incorrect reassembly may result in a risk of electric shock or fire.
Unplug the charger from the electrical outlet before attempting any
maintenance or cleaning to reduce the risk of electric shock.
Disconnect charger from the power supply when not in use. This will
