Limiter Actuation LEDs:
Please consult the
“
Limiters
” section. Whenever the Limiter(s) start
compressing the music signal to protect your system, the corresponding Yellow LED(s) will light up.
Each LED corresponds to its respective Output Group. For example, if the Limiter of Group-2 starts to
work, the Limiter LED number 2 will light up.
POWER Indication LEDs:
Please consult the
“
Power Manager
” section. These LEDs notify
you of your vehicle’s battery condition. If the battery voltage level is OK, these LEDs will be Green. If
the battery voltage level is running low, LED(s) become orange. If battery voltage level is very low,
LED(s) become Red for selected actions other than “shutdown”, or, if the “Power Manager” shuts
down the remote output(s), the corresponding LED(s) will be OFF.
GAIN CONTROL knob:
Use to control “on-the-fly” the gain (volume) of the
desired output group(s).
By default, CORE-1 comes with the knob assigned to all four output groups,
however you can (and should) change it at any time by utilizing the software. On
the lower left corner of the software, you can use the check-boxes to select the
output group(s) that the knob will be able to control. For example, if you’re utilizing
a subwoofer on Output Group-1 and you wish to control its volume with the knob,
then you
check only “1” and leave the other groups unchecked, as shown by the
example picture on the left.
