Installing the CORE-1 Signal Processor:
WARNING:
Installation of this mobile audio device requires experience with a variety of mechanical and
electrical procedures. If you don’t have the required knowledge / experience to complete
the installation, please consult an authorized Massive Audio dealer about professional
installation option. Before you begin, please note the following:
1)
Install the software BEFORE you connect the USB cable.
Insert
the CD Software, open “Core1_Installer.exe” and proceed clicking
“Next” till the end. Please consult
“Software Installation”
.
2)
Connect CORE-1 directly to the battery (12Volt DC).
Do not
power it from the ignition switch or any type of switch.
Please consult
“Power Source Connector”
.
3)
Make SURE that your vehicle’s battery is fully charged
.
We
strongly recommend using a battery charger during the setup
process
. If the battery voltage is lower than 11.5V, the CORE-1
protection features will kick in and may cause confusion. Please
consult
“Power Manager”
.
4)
If you use the High Level Input, you don’t need to connect the
remote wire input
“REM”. CORE-1 features “auto-remote.” Please
consult the
“Wiring Diagram”
for High Level audio inputs.
5)
ALWAYS connect the REMOTE of the amplifiers to the CORE-1.
Never from the Head Unit. Utilize outputs “REMOTE OUT” 1 to 4.
Please consult
“Remote Outputs”
.
6)
Set the GAIN of the Power Amplifiers to ZERO
to avoid “hiss”
noise. CORE-1 already pre-amplifies the signal. Always prefer to
adjust the gain utilizing the software. Please consult
“RCA Audio
Outputs”
.
