8600 - EAME
107
4315972M4 - 2
3
3. Operation
Crop_this_page
5.
D
ANGER
:
The ParkLock parking brake will not
operate once its screws have been
loosened.
Before loosening, chock the tractor to
prevent the wheels from drifting.
Release the ParkLock parking brake by loosen-
ing the right and left-hand brake fittings ((1)) lo-
cated on the top of the rear axle until the hard
point is felt (approximately 9 turns)
Limp home mode
If the transmission ratio control is not possible due to a breakdown, the tractor can be driven mechanically
using a limp home lever.
Maximum speed in the high speed range is 34 km/h in forward travel and 25 km/h in reverse travel.
Maximum speed in the low speed range is 15 km/h in forward travel and 11 km/h in reverse travel.
I
MPORTANT
:
When the tractor is stopped, the speed range must be in neutral position (middle position) and
the brake must be engaged.
C
AUTION
:
Once the engine has been started, the transmission is in full working order once a range (high
or low) is engaged!
The clutch pedal must be engaged with care because any transmission ratio can be preselected.
1. Stop the engine if it is running.
2. Open the cover plate located on the cab floor (right-hand side).
3. Remove the protective plate.
4.
I
MPORTANT
:
When shifting range, only use
the limp home lever supplied with the tractor
because the coupling mechanism in the control
unit may be damaged (max. permissible torque:
10 Nm).
Place the limp home lever on the range control
and select the limp home range :
–
clockwise direction, low speed range (tor-
toise)
–
anti-clockwise direction, high speed range
(hare)
N
OTE
:
It is important not to change range
when travelling in limp home mode
I007381
Fig. 27.
1
I007380
Fig. 28.
