Masport Inbuilt Gas Fireplace
- 6 -
4) Always connect this fireplace to a flue pipe
terminating outside the building envelope. Never
vent to another room. Make sure that the flue pipe
is properly sized and is of adequate height to
provide the proper draft. Use only the Masport
approved flue kit.
5) Inspect the flue system annually for blockage and
any signs of deterioration.
6) If the glass is removed for servicing it must be
replaced prior to operating the appliance.
7) To prevent injury, do not allow anyone who is
unfamiliar with its operation to use the fireplace.
8)
Always turn off the gas valve before cleaning. For
relighting, refer to lighting instructions. Keep the
burner and control compartment clean by brushing
and
vacuuming
at
least
once
a
year.
9)
When cleaning the logs, use a soft clean
paintbrush as the logs are fragile and easily
damaged.
10) Clean the appliance with a damp cloth (never
when unit is hot). Never use an abrasive cleaner.
The glass should be cleaned with a gas fireplace
glass cleaner.
11) Make a periodic check of the burner for proper
position and condition. Visually check the flame of
the burner periodically, making sure the flames
are steady, not lifting or floating. If there is a
problem call an authorised Technician.
ELECTRICAL REQUIREMENTS
Piccolo
No mains voltage electric power supply is required for
the gas control to operate, but a 240-Volt AC supply is
required for the fan. Plug the 3-pin plug and lead into a
suitable receptacle. Do not cut the earth terminal off
under any circumstances.
Sofia & Madrid
Mains voltage electric power supply is required for the
gas control to operate on these models. A 240-Volt AC
power cord is connected to the control system. Plug
the 3-pin plug into a suitable receptacle. Do not cut the
earth terminal off under any circumstances.
When connected with 240 volts, all appliances must be
electrically earthed in accordance with local codes.
INSTALLATION SEQUENCE
The Masport Gas Insert is installed in the steps as
listed below. Detailed instructions follow.
1) Check the clearances to ensure that the fire will fit
the
fireplace
recess
and
clearances
to
combustibles will be maintained. (Also check
ventilation requirements.) See page 7.
2) Prepare the fireplace recess. The base of the
fireplace must be levelled by for example grouting
to prevent vibration from possible fan imbalance.
The base of the gasfire must be sitting on this flat
surface. See page 7.
3) Install the flue or flexi-liner in accordance with AG
601 or NZS 5261, refer to instructions provided
with the Masport flue kit.
4) Install the gasfire into the fireplace recess and
connect to the flue system. See page 8.
5) Make the gas connection (see page 8) and the
electrical connection.
6) Assemble and install the fascia and switches (on
the EIS models). See pages 9 & 10.
7) Remove the glass or window assembly and install
the embers etc. See page 11 &12.
8) Re-install the glass or window assembly. See
pages 11 & 12.
9) Install louvres or grilles.
10) Final check: Before leaving this unit with the
customer, the installer must ensure that the
appliance is firing correctly. This includes:
a) Checking the injector pressure. See page 12.
b) Adjusting the primary air, if required, to ensure
that the flame does not carbon on the
components.
c) Ensuring that the flue is drawing correctly.
d) Instructing the customer in the correct
operation of the appliance.
e) Leaving these instructions with the customer.
f) Issuing a certificate of compliance.
Содержание MADRID
Страница 1: ...Masport Inbuilt Gas Fireplace 1 ...