Masport Inbuilt Gas Fireplace
- 11 -
5) Offer the fascia into position on the unit and adjust
until it fits correctly. Remove the fascia carefully
and tighten all the screws
6) The power cord should be run behind the fascia
panel and out through the slot in the bottom of the
fascia. The rubber grommet on the power cord
should be inserted into the slot to protect the mains
lead against possible damage.
Note:
There is no fan switch on the Piccolo as it
is a single speed fan.
7) Attach the assembled fascia to the case using the
4 remaining screws.
FLUSH FRONT GLASS REMOVAL
1)
Remove the top louvre by lifting it upwards and
outwards to clear the retaining pins.
2)
Remove the two trim fastening screws, one at
each end of the top trim as per the diagram below
and remove the top glass trim.
3)
Remove the 2 black cover trims one at each side
of the glass by lifting them upwards and then out.
Refer to diagram 2. Pull the top of the trim
forward before the bottom.
4)
This will now free the glass for removal from the
fire and give access to the logs, burner etc.
Diagram 2
BAY FRONT REMOVAL
1)
Remove the top grille by lifting it upwards and
outwards to clear the retaining pins.
2)
Release the bottom grille retaining screw one
quarter turn anticlockwise and remove the bottom
grille by lifting it upwards and outwards to clear
the retaining pins.
3) Remove the two window fastening screws, one at
either end of the window as per the diagram below.
4) This will now free the window for removal from the
fire by swinging the top outwards slightly and lifting
the bottom edge clear of its retaining channel. This
will give access to the logs, burner etc.
INSERT SCREWDRIVER
TO LIFT TRIM.
SIDE GLASS
TRIM
TOP GLASS
TRIM
TRIM FASTENING
SCREW.
Содержание MADRID
Страница 1: ...Masport Inbuilt Gas Fireplace 1 ...