Masdaf HEXA 1, Руководство по эксплуатации, Страница: 5 / 16

HEXA Series
5
3. SAFE OPERATING CONDITIONS
This manual contains main safety instructions for the
installation, operation and maintenance. It must be read
by the personnel who are responsible for installation and
operation. This manual should always be kept near the
installation location. It is important to comply with safety
precautions stated in page 1 along with the general safety
instructions as well as preventive measures repeated in
other sections of this manual.
3.1. Training of Personnel
Installation, operation and maintenance personnel must
have necessary knowledge in order to accomplish the
given job. The responsibility, adequacies and controlling
duties of such personnel must be determined by the
costumer. It has to be certain that these personnel
comprehend totally the content of the operating manual.
If the personnel do not have enough knowledge, required
training must be given by the costumer. If training support
is needed by the costumer, it will be provided by the
manufacturer/seller.
CAUTION
Untrained personnel and unwillingness to comply with
safety instructions may be risky for both machine and
environment. MAS DAF MAKINA SANAYI A.Ş. is not
responsible for this kind of damages.
3.2. Hazardous Conditions That May Occur When One
does not Comply With the Safety Instructions
Incompliance with safety regulations may put the
personnel, the environment and the machine in danger
and thus may cause damages. Incompliance with safety
regulations may give rise to situations listed below.
Important operational functions of the factory may stop.
Maintenance may get difficult.
One may get injured by electrical, mechanical or
chemical hazards.
3.3. Safety Measures for Operator
Dangerous, hot or cold components in the pump area
must be covered so that one cannot touch them. Moving
components of the pump (such as coupling) must be
covered so that one cannot touch them. Those covers
must not be dismounted while the pump is running.
Dangers that results from electrical connections must be
removed. To get more information about this subject, you
can refer to domestic electrical instructions.
3.4. Safety Measures for Maintenance and Installation
The costumer must assure that all maintenance, check
and installment tasks are performed by qualified
personnel. Repair work must only be performed while the
machine is not running.
The pump and its auxiliary system must be cleaned
thoroughly if it contains hazardous liquids. At the end of
the repair work, all safety and protective equipment must
be re-installed.
3.5. Spare Parts Replacement
Replacement of spare parts and all modifications must be
done after contacting with the manufacturer. Spare parts
and accessories certified by the manufacturer are
important for the safe operation of the system.
Notice: MAS DAF MAKINA SANAYI A.Ş. is not responsible
from the usage of improper spare parts.
4. TRANSPORT AND STORAGE
Suction, discharge and all auxiliary fittings must be closed
during transport and storage. Dead-end covers must be
removed while the pump unit is being installed.
4.1. Transport
Pump and pump group must be carried safely to the
installation location by lifting equipments.
CAUTION
Current general lifting safety instructions must be applied.
Please use a suspension system shown in figure while you
are carrying and lifting the pump unit. The suspension
rings may be broken because of the excessive load and
may result in a damage of the pump. Prefer fabric cable for
suspension.
Incorrect lifting may damage the pump unit and cause
injuries.
Damages caused in transport
Check the pump when it is delivered to you. Please let us
know of there is any damage.
4.2. Storage
Please keep the unit clean and dry area during storage.
If the pump is out of use for a long time, please consider
the instructions below.
1. If there is water inside the pump, drain it.
2. Clean the pump casing and impeller by jetting clean
water for a short time.
3. Empty water inside the pump casing, suction line and
discharge line.
4. Add small amount of antifreeze inside the pump casing
if it is not possible to empty it completely. Rotate the
pump shaft by hand to mix the antifreeze.