X-Fly
D
D
D1
2
C
C
A
ADJUSTMENTS
FORK LEG PRESSURIZATION
Blow pressurized air through the valves to set
COMPRESSION damping. To change the
pressure inside the fork legs, remove the
protection cap
(2)
and depressurize each
leg by pushing lightly on valve pin with a bit.
Fully tighten adapter fitting
(D)
, supplied
with the fork, on
M
ARZOCCHI
pump
(C)
.
Screw fitting end –with O-ring
(D1)
on
valve, and pressurize until the required value
is reached. Unscrew the fitting/pump as-
sembly and refit the cap
(2)
.
IMPORTANT:
inflate using special
M
ARZOCCHI
pump with pressure gauge.
Use of improper tools or other procedures
than specified ones might lead to improper
inflating.
NOTE:
in case of air leakages when adapter
fitting
(D)
is fitted, ensure that the O-ring
(D1)
is not damaged.
REBOUND ADJUSTMENT
(only right leg)
The right fork leg is equipped with an
adjuster screw
(A)
for REBOUND damp-
ing. Turning this adjuster clockwise into the
cartridge rod, changes the hydraulic set-
ting of the inner valves. In short, the amount
of adjustment applied on the piston in the
fluid determines the rate of damping.
To adjust, always start from the minimum
damping setting, i.e. unscrew completely
counterclockwise. About 8 turns - abt. 4 mm
of the adjustment - are possible.
